LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1323 (Audio/Video/Entertainment/Connectivity (Service Information)) >> Speaker >> Removal And Installation >> Subwoofer >> Removal

Removal And Installation: Subwoofer: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0163649Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the right rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL .
  3. Remove the fasteners (2a) from right rear quarter trim panel support bracket (2b).
  4. Disconnect the subwoofer assembly wire harness connector (1).
  5. Remove the fasteners (3a) for the subwoofer (4).
  6. Remove the subwoofer (4) from the cargo area.
scientia non olet · About LEMON Manuals