Description And Operation: Operation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
Two wires connected to each speaker, one feed circuit (+) and one return circuit (-), allow the audio output signal electrical current from the amplifier section of the Radio Receiver Module (RRM) to flow through each speaker voice coil.
The hardwired circuits between the RRM and the speakers may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information. The wiring information includes wiring diagrams, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds. For proper wire repair, and connector repair procedures, refer to STANDARD PROCEDURE , REMOVAL and INSTALLATION .