Removal And Installation: Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Be certain to take the proper precautions to prevent the floor console and instrument panel from receiving cosmetic damage during the following procedures.
- Position and insert the media hub bezel into the lower instrument panel trim panel (2) until all integral latches (3a) are fully engaged on the inside of the lower instrument panel trim panel (2).
- Connect the wire harness connectors (1a, 1b and 1c) to the media hub and 12V outlet.
- Install the front floor console into the vehicle. Refer to CONSOLE, FLOOR, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.