LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1323 (Audio/Video/Entertainment/Connectivity (Service Information)) >> Camera, Rear >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0180792Courtesy of CHRYSLER GROUP, LLC
  1. Position the Rear View Camera (RVC) to the RVC bezel.
  2. Install and securely tighten the fasteners (2) that secure the RVC to the RVC bezel.
  3. Connect the liftgate jumper wire harness connector (1) to the RVC.
    GC0180775Courtesy of CHRYSLER GROUP, LLC
  4. Position the RVC (2) bezel to the liftgate and press the RVC bezel into the liftgate until the retaining tabs (1) are fully engaged in the liftgate.
  5. Install the liftgate trim panel. Refer to PANEL, TRIM, LIFTGATE, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals