Removal And Installation: Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the antenna (1) into the antenna mount opening on the roof.
- Install the antenna mounting retaining fastener (4) and securely tighten.
- Connect the antenna wire harness connectors (2 and 3).
- Install the headliner. Refer to HEADLINER, REMOVAL AND INSTALLATION .
- Install the antenna mast.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
- Verify operation outside with a clear line of sight not obstructed by trees or buildings.