Removal And Installation: Removal
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the left side quarter panel trim. Refer to PANEL, QUARTER TRIM, REMOVAL .
- Remove the amplifier and mounting bracket retainers (2a and 2b).
- Pull back the foam harness protectors and disconnect the amplifier wire harness connectors (1).
- Remove the amplifier and mounting bracket from the vehicle.
- Remove the four fasteners (1a) that secure the amplifier (1b) to the mounting bracket (1c) and separate the amplifier from the mounting bracket.