LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1321 (Rear Driveline Module) >> Actuator, Axle Shaft >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the axleshaft actuator and tighten the fasteners to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  2. Connect the axleshaft actuator wire harness connector.
scientia non olet · About LEMON Manuals