Torque Specifications
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Front Lower Control Arm to Crossmember Bolt | 125 | 92 | - | |
| Front Lower Control Arm to Knuckle Bolt | 100 + 90° | 74 + 90° | - | |
| Hub Nut | 70 + 47° | 52 + 47° | - | * NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Hub and Bearing to Knuckle Bolts | 105 | 77 | - | |
| Rear Lower Control Arm to Crossmember Bolt | 125 | 92 | - | |
| Rear Lower Control Arm to Knuckle Nut | 100 + 90° | 74 + 90° | - | |
| Rear Wheel Speed Sensor to Knuckle Bolt | 7 | - | 62 | |
| Stabilizer Bar to Crossmember Bolts | 25 | 18 | - | |
| Stabilizer Bar Link to Stabilizer Bar Nut | 80 | 59 | - | * NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Stabilizer Bar Link to Strut Nut | 80 | 59 | - | * NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Strut to Body Bolts | 50 | 37 | - | * NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Strut to Knuckle Bolts | 100 + 90° | 74 + 90° | - | |
| Strut Rod to Upper Mount Nut | 70 | 52 | - | |
| Trailing Arm to Knuckle Bolt | 100 + 90° | 74 + 90° | - | |
| Trailing Arm to Body Bracket Bolt | 100 + 90° | 74 + 90° | - |