LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1319 (Chime/Buzzer/Driver Assist (Service Information)) >> Sensor, Blind Spot >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0164603Courtesy of CHRYSLER GROUP, LLC
  3. Reach up behind the outboard end of the rear bumper fascia to access and disconnect the rear bumper fascia wire harness connector (1) from the Left Blind Spot Sensor (LBSS) or Right Blind Spot Sensor (RBSS).
    GC0165792Courtesy of CHRYSLER GROUP, LLC
  4. Disengage the latch tabs of the sensor mounting bracket (1b) and pull the LBSS or RBSS (1a) out of the bracket.
  5. Remove the LBSS or RBSS (2) from the vehicle.
scientia non olet · About LEMON Manuals