LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1318 (Lamps/Lighting - Exterior (Service Information)) >> Switch, Headlamp >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. If switch bezel was removed, position the switch bezel into the instrument panel until the tabs are fully seated then install and securely tighten the fasteners.
  2. Connect the wire harness connector to the receptacle on the back of the headlamp switch.
  3. Position the headlamp switch to the instrument panel opening and push inward until the retaining clips are fully engaged.
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals