Diagnostic Test
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, read RF Hub DTCs and record on the repair order.
- Turn the ignition off and wait 30 seconds.
- Turn the ignition on and attempt to start the engine.
- If the engine started, wait 10 seconds then turn the ignition off.
- Turn the ignition on.
- With the scan tool, read RF Hub DTCs.
Is the DTC active?
Yes
- Replace the Keyless Ignition Node in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- If the DTC ever repeats, replace the Keyless Ignition Node in accordance with the Service Information.