Diagnostic Test
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE INTERNAL CONDITION
- The ABS Module is reporting internal errors.NOTE:
Before continuing, check the Anti-lock Brake System (ABS) Module harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.
- Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
- Perform any Service Bulletins that may apply.
Were there any problems found?
Yes
- Repair as necessary.
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM (ABS), REMOVAL AND INSTALLATION .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .