LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1310 (Instrument Cluster (Service Information)) >> Pod, Switch >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0163636Courtesy of CHRYSLER GROUP, LLC
  1. Position the switch pod (1b) to the instrument panel and connect the wire harness connector (2) to the switch pod (1b).
  2. Install the switch pod (1b) into the instrument panel. Be certain the switch pod retaining tabs (1a) fully engage the instrument panel.
  3. Install the radio. Refer to RADIO, REMOVAL AND INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals