Odometer Does Not Work

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

While moving, the odometer does not work, or operates erratically. The speed signal comes from the Anti-Lock Brake System (ABS) Module to the Body Control Module (BCM) via the CAN-C network and is then made available to Instrument Panel Cluster (IPC) via the CAN-B network from the BCM gateway.

0	PRELIMINARY CHECKS	Result OK	Result Not OK	Action
	Connect a diagnostic scan tool. Check that the engine is running and is not displaying any error messages	Continue to Step 2	Presence of errors	Continue to Step 1
1	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	Connect the diagnostic scan tool to read data from the BCM. Check on CAN network information: absence of non-active units absence of control in error; absence of control unit CAN communication error	Continue to Step 2	1. The presence of anomalies on CAN network 2. The presence of errors on the IPC	1. Proceed as indicated by the diagnostic tool 2. Continue to Step 2
2	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	With the diagnostic scan tool still connected to the DLC, verify the absence of anomalies on the IPC.	Continue to Step 3	Errors or failure to communicate with the diagnostic scan tool	Proceed as indicated by the diagnostic tool
3	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	With the diagnostic scan tool still connected to the DLC, check the functionality of the display by activating it with the scan tool.	Diagnostic complete	Odometer does not work	Replace the IPC