Mil Warning Light Flashes

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

The light flashes engine fault with the engine running.

NOTE:

The light may blink in two different modes: when vehicle starts and stops, or when the vehicle is placed in gear.

1	CHECK FUEL WARNING LIGHT	Result OK	Result Not OK	Action
	Check that the low fuel light is off.	Continue to Step 2	Low fuel warning light lit.	Return the fuel level above the reserve area and continue to Step 4
2	CHECK FUEL LEVEL	Result OK	Result Not OK	Action
	Verify the correct operation of the fuel level indicator.	Continue to Step 3	Fuel gauge does not work	Proceed as indicated in FUEL LEVEL INDICATOR DOES NOT WORK
3	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	Connect a diagnostic scan tool to the DLC. Verify the absence of the error "Ignition failure"	Diagnostic complete	Error Ignition Misfiring is present	Proceed as indicated by the diagnostic tool
4	CANCELLATION AND ERROR CHECKING	Result OK	Result Not OK	Action
	Clear the codes in the Powertrain Control Module using the diagnostic tool. Perform a road test and verify that the error does not recur.	Continue to Step 5	Error Ignition Misfiring is present	Proceed as indicated by the diagnostic tool
5	CHECK PROPER OPERATION	Result OK	Result Not OK	Action
	Verify that the fault is no longer present	Diagnostic complete