Low Oil Pressure Light Does Not Work

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition key on, the engine low oil pressure warning light on the instrument panel does not work.

NOTE:

The message comes from the engine oil pressure sensor signal to the Powertrain Control Module (PCM) on the CAN-C network and made available to the Instrument Panel Cluster (IPC) through the Body Control Module (BCM) via the CAN-B network.

1	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	Connect a diagnostic scan tool. Verify the absence of anomalies on the PCM and the IPC.	Continue to Step 2	Presence of anomalies in the IPC or PCM	Proceed as indicated by the diagnostic tool
2	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	With the diagnostic scan tool still connected to the DLC, test the functionality of the light in the IPC through active diagnosis	Continue to Step 3	1. The light doesn't work. 2. The light works - pressure sensor defective 3. 3. Engine oil pressure sensor wiring fault / not insulated	1. Replace instrument panel cluster 2. Replace engine oil pressure sensor 3. Restore wiring
3	CHECK PROPER OPERATION	Result OK	Result Not OK	Action
	Verify that the fault is no longer present	Diagnostic complete	anomaly persists	Replace the Body Control Module and continue to Step 4
4	CHECK PROPER OPERATION	Result OK	Result Not OK	Action
	Verify that the fault is no longer present	Diagnostic complete	Anomaly persists	Replace the Powertrain Control Module