Door Open Indicator Always On

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

After performing the initial test, the doors open indicator, located on the Instrument Panel Cluster, is always on.

0	PRELIMINARY CHECKS	Result OK	Result Not OK	Action
	Check the correct closure of the four doors	Continue to Step 1	Doors not properly closed	Ensure the doors close properly
1	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	With the diagnostic scan tool, check in the Instrument Panel Cluster the absence of errors and the presence of the parameters	Continue to Step 2	1. the scan tool cannot connect to the instrument panel cluster 2. presence of errors	1. Continue to Step 2 2. Proceed as indicated by the diagnostic tool
2	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	With the diagnostic scan tool, check in the Body Control Module (BCM) for the absence of errors and the variation of the parameter for the state of the doors	Continue to Step 4	The parameter values do not change	Continue to Step 3
3	CHECK ELECTRICAL CONNECTIONS	Result OK	Result Not OK	Action
	Check the operation of the switches on the door motors Check the ground insulation of the connection between the switches and door inputs to the BCM	Continue to Step 4	1. Switch defective 2. Wiring with imperfect ground insulation	1. Replace switch 2. Restore the wiring insulation
4	CHECK WITH ACTIVE DIAGNOSIS	Result OK	Result Not OK	Action
	With the diagnostic scan tool under Instrument Panel Cluster, check in "Active Diagnosis" the correct activation, check the open doors light	Continue to Step 5	The light check doors open is not activated	Replace instrument panel cluster
5	CHECK PROPER OPERATION	Result OK	Result Not OK	Action
	Verify that the fault is no longer present	Diagnostic complete	Anomaly persists	Replace the Body Control Module