Airbag Indicator Off (Does Not Carry Out Initial Test)

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

When the ignition key is turned on, the Air Bag indicator lights should come on for a few seconds to indicate the performance of the initial test of the control unit and then go off. The warning lights are integrated LEDs in the electronic circuit of the instrument panel cluster and therefore are NOT replaceable. If the LEDs are at fault, the instrument panel cluster must be replaced.

1	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	Connect a diagnostic scan tool. Make sure that you establish a regular communication with the Occupant Restraint Controller (ORC) and in particular: no abnormalities in ORC plausibility of all parameters	Continue to Step 2	1. Failure to communicate with the ORC 2. An error in the ORC	1. Restore: Connection between the ORC and the DLC power to the ORC 2. Proceed as indicated by the diagnostic tool
2	CHECK WITH DIAGNOSTIC TOOL	Result OK	Result Not OK	Action
	With the diagnostic scan tool still connected to the DLC, test the functionality of the Air Bag warning light through active diagnosis	Continue to Step 3	Lamp does not flash	Replace instrument panel cluster
3	CHECK PROPER OPERATION	Result OK	Result Not OK	Action
	Verify correct operation of the ORC.	Diagnostic complete	ORC not working	Replace the ORC