LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Power Transfer Unit (Service Information)) >> Actuator, Shift >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the actuator on the PTU. Install and tighten the bolts to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  2. Connect the actuator wire harness connector.
  3. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals