Park Detent And Manual Shaft Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

The transmission does not require removal to complete the following procedure.

Remove the valve body from the transmission. Refer to VALVE BODY, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Pull upward on the cable end (1) while pushing down on release button (2) to remove the shifter cable from the manual lever (3).
Remove the nut holding the manual shift lever to the manual shaft.
Pry the manual shift lever upward and off the manual shaft.

Courtesy of CHRYSLER GROUP, LLC
Remove the detent spring screws (2) and remove the detent spring (1).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not allow the roll pin to fall into the transmission.
Using a suitable pin-punch (2), carefully drive the roll-pin out of the detent hub (1).

Courtesy of CHRYSLER GROUP, LLC
Pull the manual shaft (1) out of the detent hub and transmission housing.

Courtesy of CHRYSLER GROUP, LLC
Remove the detent hub (2) and park rod (1) from the transmission.