LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (948TE Automatic Transmission (Service Information)) >> Harness, Internal Wire >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the valve body from the vehicle. Refer to VALVE BODY, REMOVAL AND INSTALLATION .
    NOTE:

    If the valve body is to be reused without disassembling it, store the valve body in a clean area until it is installed.

    GC0165022Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the wiring harness from the transmission fluid pressure transducer (1).
  3. Remove the screws from the solenoid connectors and lift the harness (2) from the valve body.
scientia non olet · About LEMON Manuals