LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (948TE Automatic Transmission (Service Information)) >> Cable, Shift >> Adjustments >> Verification

Cable, Shift: Adjustments: Verification

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the gearshift lever in Park (P).
  2. Attempt to move the vehicle by rocking it back and forth on level ground. If the vehicle does not move, attempt to start the engine. If the engine starts, the park position is correct.
  3. Press and hold the brake pedal.
  4. Turn the ignition ON without starting the vehicle, and place gearshift lever in Neutral (N).
  5. Attempt to start the engine. If the engine starts in both Neutral (N) or Park (P), the gearshift cable is adjusted properly. No adjustment is required.
  6. If the engine does not start in either Park (P) or Neutral (N), perform the adjustment procedure.
scientia non olet · About LEMON Manuals