LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (948TE Automatic Transmission (Service Information)) >> Bearings, Transfer Gear >> Removal And Installation >> Transfer Gear Outer Bearing Race >> Removal

Transfer Gear Outer Bearing Race: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Refer to REMOVAL AND INSTALLATION .
  2. Remove the bellhousing. Refer to BELLHOUSING, REMOVAL AND INSTALLATION .
  3. Position the bellhousing on a stable, clean work surface.
    GC0159862Courtesy of CHRYSLER GROUP, LLC
  4. Using tool (special tool #C-637, Slide Hammer, Universal) (1) and (special tool #9664, Remover, Bearing Cup) (2) with the tool fingers inserted in the channels behind the transfer gear outer bearing race (3), remove the transfer gear outer bearing race (3) from the bellhousing bore.
scientia non olet · About LEMON Manuals