Differential Bearing Removal
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the transmission from the vehicle. Refer to REMOVAL AND INSTALLATION .
- Remove the bellhousing. Refer to BELLHOUSING, REMOVAL AND INSTALLATION .
- Remove the differential assembly (1) from the transmission.
- Clean the differential assembly with solvent and blow it dry with regulated 344 kPa (50 psi) shop air.
- If the differential is assembled
, remove the bearings using tools (special tool #9738, Blocks, Adapter) (2), and (special tool #8513B, Insert, Crankshaft) (3), along with (special tool #C-293-PA, Puller, Press) (1), from the differential assembly (4).
- If the differential is disassembled , remove the bearings (4) using tools (special tool #C-293-37, Block Set, Puller) (2), and (special tool #9678, Press Plug) (3), along with (special tool #C-293-PA, Puller, Press) (1).