Differential Bearing Race Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
If only the bearing is being replaced, the bearing preload does not require selecting a new select shim. If the transmission housing, bellhousing or differential is replaced, the proper thickness select shim will have to be determined. Refer to STANDARD PROCEDURES .
- Wipe the bearing bores clean with a clean lint free cloth.
- Inspect the bearing bores for damage or cracks in the casting.
- Install the original (or proper new) select shim (1) in the bearing bore of the transmission housing.
- Place the NEW
bearing race (1) in the bearing bore of the transmission housing.
- Using tool (special tool #C-4310, Installer, Bearing) (2) and (special tool #C-4171, Driver Handle, Universal) (1), install the bearing race (3) in the transmission housing.
- Install the differential assembly (1) in the transmission housing.
- Place the NEW bearing race in the bearing bore of the bellhousing.
- Using tool (special tool #C-4310, Installer, Bearing) and (special tool #C-4171, Driver Handle, Universal), install the bearing race in the transmission bellhousing.
- Install the bellhousing. Refer to BELLHOUSING, REMOVAL AND INSTALLATION .
- Install the transmission in the vehicle. Refer to REMOVAL AND INSTALLATION .