Torque Specifications
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Front Stabilizer Bar Bracket to Crossmember Bolt | 45 | 33 | - | |
| Hub Nut | 200 | 148 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Hub and Bearing to Knuckle Bolts | 105 | 77 | - | |
| Lower Ball Joint to Knuckle Bolt | 60 | 44 | - | |
| Lower Control Arm to Rear Crossmember Bolt | 125 | 92 | - | |
| Lower Control Arm to Crossmember Vertical Bolt | 130 + 90° | 96 + 90° | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Lower Control Arm to Crossmember Horizontal Bolt | 130 + 90° | 96 + 90° | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Stabilizer Bar Link to Stabilizer Bar Nut | 80 | 59 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Stabilizer Bar Link to Strut Nut | 80 | 59 | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Strut to Body Bolts | 60 | 44 | - | |
| Strut to Knuckle Nuts | 100 + 90° | 74 + 90° | - | Do not reuse fastener. If removed, a new fastener must be installed and tightened to specifications. |
| Strut Rod to Strut Mount Nut | 70 | 52 | - |