LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1300 (Front Half Shaft) >> Diagnosis And Testing >> Half Shaft >> Clunking Noise During Acceleration

Clunking Noise During Acceleration

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM POSSIBLE CAUSE REPAIR
Clunk or snap noise during launch or when shifting into drive or reverse gear.
  • Loose hub nut.
  • Damaged hub splines.
  • Replace hub nut.
  • Replace hub bearing and halfshaft.
Clunking noise at low speed.
  • Severely worn or damaged tripod or Constant Velocity (CV) joint.
  • Replace halfshaft.
Rattle or clunk over bumps. Grease is slung around the undercarriage.
  • Loss of lube in CV joint boots.
  • Replace halfshaft.
scientia non olet · About LEMON Manuals