Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR THE SRI MILEAGE PROGRAMMED INTO THE PCM

Turn the ignition on.
With the scan tool, attempt to program the SRI mileage into the PCM.
With the scan tool, erase DTCs in the PCM.
Test drive the vehicle at least eight miles.
With a scan tool, read DTCs.
Is the DTC active or pending?

Yes
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL AND INSTALLATION .
- Perform the PCM VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- The SRI mileage has been successfully programmed into the PCM. Test is complete.
- Perform the PCM VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .