LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1292 (1.3L Exhaust System) >> Converter, Catalytic >> Removal And Installation >> Catalytic Converter >> Installation

Catalytic Converter: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install the catalytic converter side support brackets and tighten the bolts to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  2. If removed, install the catalytic converter support bracket and tighten the bolts to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. If removed, install the heat shield to the catalytic convertor and securely tighten the bolts and nut.
  4. If removed, install the lower mounting bracket to the catalytic converter and securely tighten the nuts.
  5. If removed, install the downstream oxygen sensor to the catalytic converter and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  6. If removed, install the upstream oxygen sensor to the catalytic converter and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  7. Install the catalytic converter with a NEW  metal gasket and securely tighten the nuts securing the catalytic converter support bracket to the crankcase.
  8. Install the side mounting bracket bolts and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  9. Install the collar bolt securing the catalytic converter to the turbocharger and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  10. Install and tighten the upper catalytic converter mounting bracket bolts and nuts to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  11. Using a NEW  gasket, install the exhaust pipe and tighten the NEW  nuts to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  12. Connect and lock the upstream oxygen sensor wire harness connector and engage the harness to the clip retainers.
  13. Connect and lock the downstream oxygen sensor wire harness connector and engage the harness to the clip retainer.
  14. Install the pressurized coolant bottle and engage the upper and lower retaining clips.
  15. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  16. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
  17. Install the turbocharger heat shield. Refer to TURBOCHARGER, REMOVAL AND INSTALLATION .
  18. Install the intake air tube. Refer to TUBE, INTAKE AIR, REMOVAL AND INSTALLATION .
  19. Install the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
  20. Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
  21. Connect the negative battery cable.
scientia non olet · About LEMON Manuals