LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Body - Interior & Exterior) >> Exterior >> CROSSMEMBER, Headlamp Mounting >> Disassembly And Assembly >> Assembly

Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the crossmember for damage and repair as necessary.
  2. Secure the A/C lines to the crossmember.
  3. Install the radiator support brackets and install the screws.
  4. Install the air bag sensors and install the nuts.
  5. Install the wiring retaining clip on the right side.
  6. Install the A/C refill valve support bracket and install the screw.
  7. Install the radiator assembly onto the lower support brackets and seat the upper supports fully.
  8. Install the upper support covers.
  9. Install the hood support rod support bracket.
  10. Install the hood support rod.
  11. Install the headlamp mounting crossmember. Refer to CROSSMEMBER, HEADLAMP MOUNTING, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals