Key Is Hard To Turn

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

STEP	WHAT TO DO	OK (no problem found)	PROBLEM FOUND	CORRECTION
1	CHECK FUNCTIONALITY OF THE LOCK CYLINDER WITH SECOND KEY	Continue to Step 2	The movement is still restricted	Replace the lock cylinder
1	Verify the correct operation of the lock cylinder, using the second key in the cylinder	Continue to Step 2	The movement is still restricted	Replace the lock cylinder
2	CHECK FUNCTIONALITY OF THE LOCK CYLINDER	Continue to Step 3	If any signs of forced entry on the lock cylinder	Replace the lock cylinder
2	Check for signs of tampering on the glove box lock cylinder.	Continue to Step 3	If any signs of forced entry on the lock cylinder	Replace the lock cylinder
3	CHECK FUNCTIONALITY OF THE LOCK CYLINDER	Proceed to Step 4	Turning torque more than 0.3 N.m	Replace the lock cylinder
	Through the opening of the lock cylinder, spray a small amount of lubricant (avoid contact with the aesthetic parts).
	Try to operate the lock mechanism; it is recommended not to exceed a torque of 2 N.m to avoid damaging the key.
4	CHECK ALIGNMENT slats OF THE LOCK CYLINDER	End of diagnosis	Slats are not aligned properly	Replace the lock cylinder
4	Pull the lock and, after inserting the key, verify the complete alignment of the slats	End of diagnosis	Slats are not aligned properly	Replace the lock cylinder