LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Body - Interior & Exterior) >> DECKLID/Hatch/Liftgate/Tailgate/Swing Gate >> Liftgate >> Disassembly And Assembly >> Disassembly

Disassembly And Assembly: Disassembly

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The operation should be carried out with the liftgate removed.

GC0163686Courtesy of CHRYSLER GROUP, LLC
  1. Remove the liftgate glass. Refer to GLASS, LIFTGATE, REMOVAL  .
  2. Remove the wiper motor. Refer to MOTOR, WIPER, REAR, REMOVAL .
  3. Remove the liftgate and place it on a work bench. Refer to LIFTGATE, REMOVAL  .
  4. Remove the liftgate latch (1b). Refer to LATCH, LIFTGATE, REMOVAL  .
  5. Release the liftgate release switch retainers (2a).
  6. Disconnect the wiring connector and remove the liftgate release switch (2b).
    GC0163232Courtesy of CHRYSLER GROUP, LLC
  7. Using trim stick or equivalent, release the license plate light retainers (1b).
  8. Disconnect the license plate lamp wiring connector and remove the lamp (1a).
    GC0163909Courtesy of CHRYSLER GROUP, LLC
  9. Unscrew the rubber bumper (1) and remove.
  10. With the use of a drill equipped with an appropriate tip, remove the rivets (2a) and the tail lamp pad (2b).
scientia non olet · About LEMON Manuals