LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Body - Interior & Exterior) >> DECKLID/Hatch/Liftgate/Tailgate/Swing Gate >> Liftgate >> Disassembly And Assembly >> Assembly

Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0163909Courtesy of CHRYSLER GROUP, LLC
  1. Position the tail lamp pad (2b) and install NEW  rivets (2a).
  2. Install the rubber bumper (1).
    GC0163232Courtesy of CHRYSLER GROUP, LLC
  3. Connect the wire harness connector to the license lamp (1a).
  4. Install the license lamp.
    GC0163686Courtesy of CHRYSLER GROUP, LLC
  5. Connect the wire harness connector to the liftgate release switch (2b).
  6. Install the liftgate release switch.
  7. Install the liftgate latch. Refer to LATCH, LIFTGATE, INSTALLATION  .
  8. Install the liftgate. Refer to LIFTGATE, INSTALLATION  .
  9. Install the liftgate glass. Refer to GLASS, LIFTGATE, INSTALLATION  .
  10. Install the wiper motor. Refer to MOTOR, WIPER, REAR, INSTALLATION .
scientia non olet · About LEMON Manuals