Description And Operation: Operation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

The blower motor controls the velocity of air moving through the HVAC housing by spinning the blower wheel within the HVAC air inlet housing at the selected speed.

Both the Manual Temperature Control (MTC) HVAC system and the Automatic Temperature Control (ATC) HVAC system have an electronic blower motor power module to control blower motor speed. The power module uses a Pulse Width Modulated (PWM) input from the A/C heater control and a feedback signal from the blower motor to regulate the blower motor ground path. On both systems, the blower motor receives battery current through the Power Distribution Center (PDC) whenever the ignition switch is in the RUN position, and the blower motor control is in any position except OFF.

The blower motor control system is diagnosed using a scan tool. Refer to STANDARD PROCEDURE .

The blower motor and blower motor wheel are factory balanced as an assembly and cannot be adjusted or repaired and must be replaced if inoperative or damaged.