Description And Operation: Operation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

The A/C pressure transducer is connected to a 5 volt supply voltage. Utilizing sensing elements and internal electronics, it creates a voltage signal that is proportional to the pressure. This voltage is received by the Powertrain Control Module (PCM) or Engine Control Module (ECM), where it is converted to a pressure value, and broadcasts the information from the PCM/ECM over the Controller Area Network - Chassis (CAN-C) bus for use by the other modules.

The PCM/ECM is programmed to respond to this and other sensor inputs to control the operation of the A/C compressor and the radiator cooling fan to optimize A/C system performance and to protect the system components from damage. The PCM will not operate the A/C compressor if there are any A/C pressure transducer circuit faults detected.

The A/C pressure transducer is factory calibrated and cannot be adjusted or repaired and must be replaced if inoperative or damaged.