LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1288 (Heating & Air Conditioning (Service Information)) >> Cabin Heater >> Unit, Heater >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0164308Courtesy of CHRYSLER GROUP, LLC
  1. Carefully install the positive temperature coefficient (PTC) heater (cabin heater) unit (2a) into the HVAC air distribution housing. Be certain to engage the heater unit to the centering pin (2b).
  2. Install and securely tighten the fastener (1) that secures the PTC heater unit to the air distribution housing.
    GC0164039Courtesy of CHRYSLER GROUP, LLC
  3. Connect the wire harness connector (2a) to the PTC heater unit.
  4. Position the PTC relay assembly bracket (1d) to the HVAC air distribution housing and install and securely tighten the fasteners (1b) for the relay bracket (1c).
  5. Connect the wire harness connector (1a) to the PTC heater relay assembly (1d).
  6. Install the right front center console trim panel.
  7. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals