LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1287 (Frame And Bumpers) >> Bumpers >> Fascia, Front Cover >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the fascia cover is not damaged.
  2. Position the fascia cover and seat the retaining clips fully.
  3. Install the park sensors, if equipped. Refer to SENSOR, PARK ASSIST, REMOVAL AND INSTALLATION .
  4. Install the wheelhouse splash shield on the side of the vehicle being worked on. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
scientia non olet · About LEMON Manuals