Removal And Installation: Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Coat the valve stems (2) with clean engine oil and install the valves into the cylinder head.NOTE:
If the valves are being reused, reassemble them into their original locations.
- If the valves or valve seats have been refinished, check the valve tip height (5). If the valve tip height (5) exceeds the specification, grind the valve tip until it is within specification. Refer to SPECIFICATIONS
. Make sure the measurement is taken from the cylinder head surface (7) to the top of the valve stem (2).
- If removed, install the valve guide seal (2) over the valve guide (3).NOTE:
Make sure that the garter spring (1) is intact around the top of the valve guide seal (2).
- Install the valve spring(s). Refer to
SPRING(S), VALVE, REMOVAL AND INSTALLATION
.NOTE:
Reassemble the valves springs into their original locations. If the valves or valve seats have been refinished, verify that the valve spring installed height is within specification. Refer to SPECIFICATIONS .
- Install the cylinder head. Refer to CYLINDER HEAD, REMOVAL AND INSTALLATION .