LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1286 (2.4L Engine (Service Information)) >> Cylinder Head >> Seal(S), Valve Guide >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install the valve(s). Refer to VALVES, INTAKE AND EXHAUST, REMOVAL AND INSTALLATION  .
    GC0155796Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Valve spring seats are integral to the stem seal and are common Intake and exhaust.

  2. Apply engine oil to the lip of the valve guide seal (2). Install the valve guide seal over the valve stem. Using an appropriate driver, push the seal firmly and squarely over the valve guide. Do Not Force  the seal against the top of guide.
    NOTE:

    Make sure that the garter spring (1) is intact around the top of the valve guide seal.

  3. Install the valve spring(s). Refer to SPRING(S), VALVE, REMOVAL AND INSTALLATION  .
scientia non olet · About LEMON Manuals