LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1285 (2.4L Fuel System) >> Fuel Injection >> Sensor, Manifold Air Pressure (Map) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the manifold air pressure sensor and turn it 90 degrees clockwise.
  2. Connect the wire harness connector to the manifold air pressure sensor.
  3. Install the tubing from the air filter to the throttle body, throttle body side, and securely tighten the clamp.
  4. Connect the wire harness connector to the air temperature sensor.
  5. Connect the air hose from the filter to the throttle body, filter side, and securely tighten the clamp.
  6. Connect the engine oil vapor hose quick coupling.
  7. Securely tighten the air tube to the throttle body clamp.
  8. Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals