Removal And Installation: Removal
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the right rear splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
- Remove the fuel fill housing. Refer to HOUSING, FUEL FILL, REMOVAL
.
- Remove the fuel filler tube retaining screw (1).
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE
.
- Loosen the clamp and disconnect the hose from the fuel filler tube (1).
- Disconnect the fuel vapor line quick connector (1).
- Remove the retaining nut (2), securing the fuel filler tube to the body.
- Remove the fuel filler tube (3).