Removal - Front Fuel Delivery Line - 2.4L
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Open the cover of the Power Distribution Center (PDC) in the engine compartment and remove the fuel pump fuse (F21 - 15 ampere).
- Start the engine and run until the fuel in the lines is depleted.
- Reinstall the fuel pump fuse (F21 - 15 ampere) and close the PDC cover.
- Remove the engine cover. Refer to
COVER, ENGINE, REMOVAL AND INSTALLATION
.
- Remove the bolt (1) from the clean air hose which goes between the air cleaner body cover and the throttle body.
- Disconnect the engine oil vapor hose quick coupling (2).
- Loosen the clamp (3) and disconnect the clean air hose (3) from the air cleaner body cover.
- Disconnect the wire harness connector (1) from the inlet air temperature sensor.
- Loosen the clamp (2) and remove the clean air hose (2).
- Disconnect the quick coupling (1) on the right end of the front fuel delivery line.
- Disconnect the quick coupling (1) on the left end of the front fuel delivery line and remove the line from the vehicle.