LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1284 (1.3L Fuel System) >> Fuel Injection >> Throttle Body >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new gasket on the inlet manifold.
  2. Install the throttle body retaining screws and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Connect the wire harness connector to the throttle body.
  4. Install the turbocharger to throttle body air outlet pipe. Refer to COOLER AND HOSES, CHARGE AIR, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals