LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1284 (1.3L Fuel System) >> Fuel Delivery >> Sensor, Fuel Rail Pressure >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE  .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
  4. Thoroughly clean the area around the fuel pressure sensor to prevent contaminates from entering the fuel system.
    GC0189471Courtesy of CHRYSLER GROUP, LLC
  5. Unlock and disconnect the fuel pressure sensor wire harness connector (1).
    GC0188825Courtesy of CHRYSLER GROUP, LLC
  6. Remove the fuel pressure sensor (1).
scientia non olet · About LEMON Manuals