160, 000KM Service (Diesel)
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Check tire conditions / wear and adjust pressure, check expiration date on the Tire Service Kit charge (if any).
- Check lighting system operation (headlights, turn signals, rechargeable flashlight, passenger compartment, glove box, instrument panel warning lights, etc.).
- Check and restore fluid levels (engine coolant, brake / hydraulic clutch, windshield washer, battery, etc.).
- Check emissions / exhaust gas. Refer to the appropriate service information .
- Check engine control system operation and engine oil degradation (via scan tool).
- Check cleanness of locks, hood and trunk lever cleanness and lubrication.
- Visually check condition and pad wear of the front disc brakes and operation.
- Visually check condition and pad wear of the rear disc brakes and operation.
- Replacing oil and oil filter is indicated by light or message on the instrument panel depending on the use of the car. Must not exceed 2 years.
- If the vehicle is used mainly on urban routes you need to replace the engine oil and filter every year.
- To replace oil and oil filter. Refer to FILTER, ENGINE OIL, REMOVAL AND INSTALLATION, 1.3L or FILTER, ENGINE OIL, REMOVAL AND INSTALLATION, 2.4L .
- If refueling the vehicle with fuel of inferior quality to the European specification provided it is recommended to replace the fuel filter cartridge, operating as described below.
- Replace the fuel filter cartridge, operating as described below. Refer to the appropriate service information .
- Position the fuel filter in vise with protective jaws.NOTE:
To avoid compromising the functionality of the new filter element, it is recommended to protect hands with suitable gloves when opening the protective and all stages of assembly.
- Remove the screws (1a), remove the cover (1b) complete with filter element (1c) and place in a suitable container.
- Remove the filter element (1a) from the cover (1b).NOTE:
To avoid compromising the functionality of the new filter element, it is recommended to protect hands with suitable gloves when opening the protective and all stages of assembly.
- Assemble by pressing the new filter element (1a) in the lid (1b) engaging the water drain line (1c) in the hole (1d) of the bleed valve.
- Check the correct position of the water presence sensor (1a) and seal ring (1b).
- Place the filter element in the housing, taking care to engage the tooth with the groove (1) of the support.
- Tighten the mounting screws on cover of fuel filter.
- Remove the fuel filter from the vise. Refer to the appropriate service information .
- If the vehicle is used in dusty conditions replace the engine air filter. Refer to AIR CLEANER, REMOVAL AND INSTALLATION, 1.3L or AIR CLEANER, REMOVAL AND INSTALLATION, 2.4L .
- If the vehicle is used in dusty conditions replace the cabin air filter. Refer to FILTER, CABIN AIR, REMOVAL AND INSTALLATION .