150, 000KM Service (Diesel And Gas)
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Check tire conditions / wear and adjust pressure, check expiration date on the Tire Service Kit charge (if any).
- Check lighting system operation (headlights, turn signals, rechargeable flashlight, passenger compartment, glove box, instrument panel warning lights, etc.).
- Check and restore fluid levels (engine coolant, brake / hydraulic clutch, windshield washer, battery, etc.).
- Check emissions / exhaust gas. Refer to DIAGNOSIS AND TESTING .
- Check engine control system operation and engine oil degradation (via scan tool).
- Visually inspect conditions and integrity: exterior bodywork, underbody protection, pipes and hoses (exhaust, fuel system and brakes), rubber parts (boots, sleeves, bushings, etc.).
- Check cleanliness of locks, hood and trunk lever cleanness and lubrication.
- Visually check condition and pad wear of the front disc brakes and operation.
- Visually check condition and pad wear of the rear disc brakes and operation.
- Check belt tension on accessory drive (versions without automatic tensioner).
- To replace oil and oil filter. Refer to
FILTER, ENGINE OIL, REMOVAL AND INSTALLATION, 1.3L
or FILTER, ENGINE OIL, REMOVAL AND INSTALLATION, 2.4L
. If the vehicle is used with an annual mileage below 10, 000 km replace engine oil and filter every year.NOTE:
In order to ensure proper functionality and avoid serious damage to the engine, it is essential: only use spark plugs specifically certified for such engines, the same type and the same brand; strictly enforce the change interval of spark plugs provided in the Service Schedule.
- Replace the spark plugs operating as described below.
- Disconnect the electrical connections of the ignition coils (1).
- Remove the screws (2a) and remove the ignition coils (2b).
- With appropriate tool (1a), unscrew and remove the spark plug (1b) from the engine.
- Install the new engine spark plugs and tighten them to the specified torque.
- Install the ignition coils and tighten the screws to the specified torque.
- Connect the electrical connections of the ignition coils.
- Replace the engine air filter. Refer to AIR CLEANER, REMOVAL AND INSTALLATION, 1.3L or AIR CLEANER, REMOVAL AND INSTALLATION, 2.4L .
- Replace the brake fluid. Refer to STANDARD PROCEDURE .
- Replace the cabin air filter. Refer to FILTER, CABIN AIR, REMOVAL AND INSTALLATION .