LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) >> Lubrication >> Cooler, Oil >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable.
  3. Drain the engine cooling system. Refer to DRAINING AND FILLING THE COOLING SYSTEM - 1.3L .
  4. Remove the clean air hose. Refer to HOSE, CLEAN AIR, REMOVAL AND INSTALLATION  .
  5. Remove the generator. Refer to GENERATOR, REMOVAL AND INSTALLATION .
  6. Remove the accessory drive belt tensioner. Refer to TENSIONER, BELT, REMOVAL AND INSTALLATION .
  7. Remove the water pump inlet tube. Refer to PUMP, WATER, REMOVAL AND INSTALLATION .
    GC0189103Courtesy of CHRYSLER GROUP, LLC
  8. Loosen the band clamp and remove the coolant inlet hose (1a) from the oil cooler (1b).
    GC0190302Courtesy of CHRYSLER GROUP, LLC
  9. Remove the bolts (1a) and remove the engine oil cooler (1b).
    GC0189306Courtesy of CHRYSLER GROUP, LLC
  10. Remove the metal seal (1b) from the oil cooler (1a).
scientia non olet · About LEMON Manuals