LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) >> Lubrication >> Cooler, Oil >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Position the engine oil cooler with a new metal seal onto the engine and loosely install the bolts.
    GC0188779Courtesy of CHRYSLER GROUP, LLC
  2. Tighten the bolts in the sequence shown to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Install the coolant inlet hose to the engine oil cooler and tighten the band clamp.
  4. Install the water pump inlet tube. Refer to PUMP, WATER, REMOVAL AND INSTALLATION .
  5. Install the accessory drive belt tensioner. Refer to TENSIONER, BELT, REMOVAL AND INSTALLATION .
  6. Install the generator. Refer to GENERATOR, REMOVAL AND INSTALLATION .
  7. Install the clean air hose. Refer to HOSE, CLEAN AIR, REMOVAL AND INSTALLATION  .
  8. Fill the engine cooling system. Refer to DRAINING AND FILLING THE COOLING SYSTEM - 1.3L .
  9. Connect the negative battery cable.
  10. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals