LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) >> Engine Block >> FLEXPLATE >> Removal And Installation >> Removal

Removal And Installation: Removal

CAUTION:

Do not use an impact socket or a thick walled socket when removing or installing the flexplate retaining bolts, damage to the crankshaft, internal engine or the transmission may occur.

  1. Remove the transmission. Refer to REMOVAL AND INSTALLATION .
    GC0207928Courtesy of CHRYSLER GROUP, LLC
  2. Install the (special tool #10272, Tool, Flywheel Locking) (1).
  3. Remove and discard the bolts (2a) and remove the flexplate (2b).
  4. Remove the flywheel locking tool (1).
  5. Using a suitable tool clean all sealant from the bolt holes.
scientia non olet · About LEMON Manuals