LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.3L Engine (Service Information) >> Cylinder Head >> Pump, Vacuum >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Disconnect and isolate the negative battery cable.
  2. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL  .
  3. Remove the powertrain control module (PCM). Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
    GC0189834Courtesy of CHRYSLER GROUP, LLC
  4. Release the quick-coupling and disconnect the brake booster vacuum hose (1).
    GC0188737Courtesy of CHRYSLER GROUP, LLC
  5. Remove three bolts (1a) and remove the vacuum pump with the seal (1b).
    CAUTION:

    When servicing components near the vacuum pump, avoid contact with the plastic nipple/connector fitting that connects the vacuum pump to the brake booster hose. It is possible to crack the plastic nipple resulting in a brake booster vacuum leak.

scientia non olet · About LEMON Manuals